
                    Accton SmartEnabler Installation
                       FOR  SCO UNIX


README.TXT      This file
                Installation procedure file
SCOLSEN.TAR     Accton SmartEnabler driver for SCO UNIX tar format

-----------------------------------------------------------------------------
Note for Scenic 500/700:  Pleas set your notebook BIOS Plug and Play OS to NO.
-----------------------------------------------------------------------------

      1.0 Installation for SCO 5 enabler from tar file

      1.1 To install the Accton SmartEnabler from file to SCO 5:
          -----------------------------------------------------------

        1. Go to the /tmp in Unix system.

                cd /tmp                         <Enter>

        2. Copy the scolsen.tar file from the DOS diskette to /tmp directory:

                doscp a:scolsen.tar scolsen.tar.Z <Enter>

        3. uncompress the file:

                uncompress scolsen.tar.Z scolsen.tar             <Enter>

        4. package installation diskette ( floppy A)

              #dd if=./scolsen.tar of=/dev/rfd0135ds18 <Enter>

       (Note: Use another device file name if you use different floppy drive)

   Now the package installation diskette is ready for installing.



        5. Install the smart enabler  using the custom command


                custom         <Enter>



        Note:   This driver for SCO  will auto-detect the installed
                NE2000 or (nat0) driver and set the IO and IRQ
                accordingly.  If the NE2000 or nat0 is not installed
                it will set the IO and IRQ to default values
                at IO=0x300 and IRQ=5.

        Note also:  Please remove the old driver before installing the new one.
        Please make sure your notebook configuration will NOT conflict.


        After running the custom utility and the new package is installed,
        you should use the "netconfig" command to add the driver into your
        system like the step 6 below.

        6. Run "netconfig". Add the desired chain. The NE2000 driver are
        called:
        Remember the nat0 must be configured first, before any
        other driver is configured.

        7. When the chain has been configured, select 'q' from the
           netconfig menu. and relink the kernel at the prompt.

        8. To active the adapter, you must reboot. When the system
           boots, you should see the following message among the
           other configuration messages:

    %natn0  0x0300-0x0319   3   -   type=InfoMover addr=00-00-e8-xx-xx-xx

           with the appropriate I/O addresses, IRQ, Adapter Type and IEEE address.
           The display of last three bytes of IEEE address depends on the adapter
           currently plugged onto your system.

        9. If you encounter any problems during installation,
           (i.e., an error message appears on screen) call your dealer for assistance.

