March 15, 1991

                   ACCTON Ethernet LAN Adapter
           PC-NFS Software Interface Program Installation
           ==============================================

Using any ACCTON Ethernet LAN Adapter and the ACCTON PC-NFS
Software Interface Program, you can run the Sun MicroSystems
PC-NFS on your PC.

The following files will be used in this installation:

    Files          Contents
    --------       --------------------------------------------
    PCNFSIF.SYS    PC-NFS Software Interface Program
    NE2PD.COM      ACCTON Packet Driver for EN1622/23

The steps to install the program are as follows:

1.  Start the installation process by following the procedure
    described in the PC-NFS Manual for installing the Sun Microsystems
    PC-NFS program in your PC's hard disk.  When asked to identify
    the type of network interface card you are using, select "WD8003"
    from the list.  Likewise, when asked for the interrupt level
    and the base I/O address select:

               Interrupt Level (IRQ) 3
               I/O Base Address 300h

2.  Copy the following files to the \NFS directory of your hard
    disk:

               PCNFSIF.SYS
               NE2PD.COM

3.  Modify the CONFIG.SYS file to include the following:

               DEVICE=C:\ANSI.SYS
               DEVICE=C:\NFS\PCNFS.SYS
               DEVICE=C:\NFS\SOCKDRV.SYS
               DEVICE=C:\NFS\PCNFSIF.SYS
               LASTDRIVE=V

4.  Create or modify an existing AUTOEXEC.BAT file to include
    the following:

               C:\NFS\NE2PD 98
               SET PATH = C:\; C:\NFS
               SET TZ=CST6
               SET NFSDRIVE=C
               PRT *
               NFSRUN

    For your system to work properly, make sure that the
    C:\NFS\NE2PD 98 command line is placed before the NFSRUN
    command line.  For more information on the NE2PD.COM program,
    refer to the READ.ME file of the ACCTON Packet Driver for
    the EtherPair-NE2 and the EtherCoax-NE2 adapters.

    Allowable values for the software interrupt vector range from
    96 to 128.  The default software interrupt vector value is 98.

5.  Reboot the PC and start the PC-NFS program.  You may now run
    PC-NFS commands on your PC to allow communication with other
    computers on the network that use the TCP/IP protocol.





