

                      Accton Technology Corporation
             PC-NFS Software Interface Program Installation
                    For EN2212 Ethernet PCMCIA Adapters

    Copyright (C) 1994, 1995 by Accton Technology Corporation.
    All rights reserved.


Use the Accton EN2212 Ethernet LAN Adapter and the Accton PC-NFS Software 
Interface Program, you can run the Sun MicroSystems PC-NFS on your PC.

The following files will be used in this installation:

    Files                Contents
    --------------------------------------------------------------
    PCNFSIF.SYS          PC-NFS Software Interface Program
    PCMPD.COM            Accton Packet Driver for NE & WD serials cards

INSTALLATION PROCEDURE:

1.  Start the installation process by following the procedure described in the
    PC-NFS Manual for  installing the Sun Microsystems PC-NFS program in your
    PC's hard disk.  When asked to identify the type of network interface 
    card, select "WD8003" from the list.  Likewise, when asked for the
    interrupt level and the base I/O address, select:

              Interrupt Level (IRQ) 5
              I/O Base Address 300h

2.  Copy the following files to the \NFS directory on your hard disk:

              ACCOPEN.EXE
              PCNFSIF.SYS
              PCMPD.COM

3.  Modify the config.sys file to include the following:

              DEVICE=C:\ANSI.SYS
              DEVICE=C:\NFS\ACCOEPN.EXE /int=5 /port=300
              DEVICE=C:\NFS\PCNFS.SYS
              DEVICE=C:\NFS\SOCKDRV.SYS
              DEVICE=C:\NFS\PCNFSIF.SYS
              LASTDRIVE=V

4.  Create or modify an existing autoexec.bat file to include the following:

              C:\NFS\PCMPD 98
              SET PATH = C:\; C:\NFS
              SET TZ=CST6
              SET NFSDRIVE=C
              PRT *
              NFSRUN

    For  your  system  to work properly,  make sure the C:\NFS\PCMPD  98
    command line is placed before the NFSRUN command line. 

    Allowable values for the software interrupt vector range from 96 to 128. 
    The default software interrupt vector value is 98.

5.  Reboot the PC and start the PC-NFS program.  You may now run PC-NFS 
    commands on your PC to communicate with  other computers on the network 
    that use the TCP/IP protocol.

-- THE END --
