D-Link Support Publishing       \NDIS\IBMLAN.TXT                November 1996

        D-Link PCI Family Ethernet Adapter Installation
                   for IBM LAN Support and LAN Services


 Contents
 
     Introduction
     Requirements
     Minimum Skill Level
     Compatibility List
     Getting Started

 Introduction
 
    This installation assumes that the adapter is working properly.
    Getting Started will describe the installation instructions.

 Requirements
 
     A PCI compatible computer
     IBM LAN SUPPORT and LAN Services
     A PCI Family Series Adapter
     A knowledge of basic DOS commands and editing text files

 Minimum Skill Level
 
     A knowledge of basic DOS commands
     A knowledge of editing text files
     A knowledge of DOS basic file structure (CONFIG.SYS and AUTOEXEC.BAT)
     A knowledge of the network driver configuration being used


 Compatibility List
 
     Any PCI Family Ethernet Adapter
     For a Motherboard compatibility list please consult your local
      D-Link Branch Office

 Getting Started
 

    Installation for IBM Lan Support 1.3x (see below for Lan Services 4.x)
    

    Please use Method 1 or 2 for this installation

    Method 1
    
      Using the .NIF file:

         Insert the LAN Support diskette into Drive A.

         Run the install program.

          A:\> DXMAID [Enter]

         The following message then appears:

          "Do you have driver diskettes?"  [Yes]

          (You can press [Space] to switch between No and Yes.)

         After copying LAN Support, specify the drive and path of the DOS NDIS
          files reside.

          For example: C:\LSP [Enter]

         The installation procedure terminates after the necessary files are
          copied.

    Method 2
    
      Modifying the contents of the CONFIG.SYS and PROTOCOL.INI files after 
      installing other NICs

         Copy the DLKPCI.DOS file to the directory where your IBM LAN
          Support program resides.

         Modify the NDIS device driver statement in the CONFIG.SYS as below:

          DEVICE = [drive]:\path\DLKPCI.DOS

         Modify the PROTOCOL.INI file as below:

          BINDINGS = DLKPCII_NIF
               :
               :
          [DLKPCII_NIF]
          DRIVERNAME = DLKPCI$


    IBM LAN Services v4.x installation instructions
    

     Execute the installation program from the IBM DOS LAN SERVICES diskette.

        Type: >a:\install

     From the Network card field, select 
      "Network card not shown in list below...".

     Specify the path for the corresponding oemsetup.inf file of the OEM
      driver intended for use.  Then, press Enter. The program then displays
      the driver name.

     Check that the driver configuration is correct or nit.

     Complete the installation, restart your system to use the DOS LAN
      Services.


