D-Link Support Publishing       \NDIS\MSCLIENT.TXT              November 1996

                 D-Link PCI Family Ethernet Adapter Installation
                   for Microsoft Network Client 3.0 for MS-DOS

 Contents
 
     Introduction
     Requirements
     Minimum Skill Level
     Compatibility List
     Getting Started

 Introduction
 
    This installation assumes that the adapter is working properly.
    Getting Started will describe the installation instructions.

 Requirements
 
     A PCI compatible computer
     Microsoft Network Client
     A PCI Family Series Adapter
     A knowledge of basic DOS commands and editing text files

 Minimum Skill Level
 
     A knowledge of basic DOS commands
     A knowledge of editing text files
     A knowledge of DOS basic file structure (CONFIG.SYS and AUTOEXEC.BAT)
     A knowledge of the network driver configuration being used


 Compatibility List
 
     Any PCI Family Ethernet Adapter
     For a Motherboard compatibility list please consult your local
      D-Link Branch Office

 Getting Started
 

 [Method 1]:

       Execute SETUP.EXE from Microsoft Network Client for DOS release
        diskette.

       Specify the <target path> which Microsoft Network Client for DOS
        files will been copy.

       Select "Network adapter not shown on list below ...".

       Please specify the location (path, C:\NDISDOS) of the OEM driver
        you want to use, press <Enter>.

       Select "D-Link PCI Ethernet Adapter".

       Select "Change Network Configuration", "Add Protocol" as you want.

       Follow screen instructions to complete the process. Simply
        pressing <Enter> for each screen display will select the default
        options. Press <Enter> until you reach the display prompting you
        to reboot your system.


 [Method 2]:

       Please Change to the Microsoft Network Client subdirectory,
        and run SETUP.EXE. (default directory is C:\NET)

       The screen will display some information. Press <Enter> .

       Responds to the screen prompts, selecting 
        "Change Network Configuration", then press <Enter>.

       Move the highlight to "Add Adapter", press <Enter>.

       Select "Network adapter not shown on list below ...".

       Please specify the location (path, C:\NDISDOS) of the OEM driver
        you want to use, press <Enter>.

       Select "Add Protocol" as you wish.

       Follow  screen  instructions  to  complete  the  process. Simply
        pressing <Enter> for each screen display will select the default
        options. Press <Enter> until you reach the display prompting you
        to reboot your system.

