D-Link Support Publishing       \NETWARE\NW311.TXT              November 1996

		  D-Link PCI Family PCI  Ethernet PCI Adapter
	 Driver Installation for Novell NetWare version 3.11 Server

 Contents
 
     Introduction
     Requirements
     Minimum Skill Level
     Compatibility List
     Getting Started

 Introduction
 
    This installation assumes that the adapter is working properly.
    Getting Started will describe the installation instructions.

 Requirements
 
     A PCI compatible computer
     Novell NetWare version 3.11 network operating system
     A PCI Family Series Adapter
     Knowledge of basic DOS commands and editing text files

 Minimum Skill Level
 
     Knowledge of basic DOS commands
     Knowledge of editing text files
     Knowledge of DOS bootup sequence (CONFIG.SYS and AUTOEXEC.BAT)
     Knowledge of the network driver configuration being used

 Getting Started
 

     Under MS-DOS mode, run the installation program included in the
      released diskette to extract the Novell NetWare version 3.11 server 
      driver on the server.

     Make a note of the target path where the drivers are installed.

     Copy the DLKPCI.LAN from the target path into the subdirectory of
      your server.

     > Copy C:\<PATH>\DLKPCI.LAN C:\NWSERVER

      Note: C:\SRV311 if the default path of the driver installation
            program is used.

     Copy all supplied NLM files to your server directory:

     >Copy  C:\<PATH>\*.NLM  C:\NWSERVER

     Run SERVER.EXE from your server

     Edit AUTOEXEC.NCF file

     :load install
      Select <System Option>
      Select <Edit Autoexec.NCF file>

     Modify the server's AUTOEXEC.NCF as following.
		load c:\NWSERVER\patchman.nlm
		load c:\NWSERVER\lslenh.nlm
		load c:\NWSERVER\msm31x.nlm
		load c:\NWSERVER\ethertsm.nlm
		load c:\NWSERVER\DLKCPI.lan slot=??
		bind ipx to DLKPCI  net=xxxx

     Press  <ESC> Key when done editing
      Select "YES" to save
      Select "EXIT" to leave installation

     Reboot the Server again.  The Ethernet driver is now installed.
