D-Link Support Publishing       \NETWARE\NW312.TXT              November 1996

          D-Link PCI Family PCI Ethernet Adapter Installation
                   for the NetWare Server 3.12 Driver

 Contents
 
     Introduction
     Requirements
     Minimum Skill Level
     Compatibility List
     Getting Started

 Introduction
 
    This installation assumes that the adapter is working properly.
    Getting Started will describe the installation instructions.

 Requirements
 
     A PCI compatible computer
     An ODI compatible network operating system
     A PCI Family Series Adapter
     A knowledge of basic DOS commands and editing text files

 Minimum Skill Level
 
     A knowledge of basic DOS commands
     A knowledge of editing text files
     A knowledge of DOS basic file structure (CONFIG.SYS and AUTOEXEC.BAT)
     A knowledge of the network driver configuration being used

 Compatibility List
 
     Any PCI Family Ethernet Adapter
     For a Motherboard compatibility list please consult your local
      D-Link Branch Office
     Because this driver  follows  Novell  ODI  Driver Specification
      version 3.3, the NetWare version 4.10 NetWare server must be patched
      to work with this driver. The servers of NetWare version 4.11 and
      above do not need to be patched. The patching method is described
      as below:

       1. Copy LOADER.EXE and LSWAP.EXE to the NetWare 4.10 server
          directory.

       2. Execute LSWAP.EXE at MS-DOS prompt from server directory.

          Usage: LSWAP [loaderFilePath [serverFilePath]]
                 Default loaderFilePath = C:\NWSERVER\LOADER.EXE
                 Default serverFilePath = C:\NWSERVER\SERVER.EXE

 Getting Started
 

     Copy the DLKPCI.LAN file from the <PATH>\DLKPCI.lan directory into the
      subdirectory of your server. Type:

        >copy <PATH>\DLKPCI.lan  \NW312

        ; if NW312 is the server subdirectory
        ; <PATH> is the path where DLKPCI.lan resides. If the autoinstall
          was used <PATH>=\SRV312.

     Copy all provided NLM files into your server directory. Type:

        >copy <PATH>\*.NLM  \NW312

     Run SERVER.EXE on the server.

     Edit the AUTOEXEC.NCF file as follows:

        :load install
         Select <System Option>
         Select <Edit Autoexec.NCF file>

     Modify the server's AUTOEXEC.NCF as follows:

        load C:\NW312\NBI31X.NLM
        load C:\NW312\MSM.NLM
        load C:\NW312\ETHERTSM.NLM
        load C:\NW312\DLKPCI.LAN SLOT=??
        bind ipx to DLKPCI net=xxxx  ;xxxx is the network # ie. 33

     Press Esc after editing.

     Select "Yes" to save.

     Select "Exit" to exit installation.

     Shut down the server and then turn it ON again.

     The driver is now installed and running.

