   LAN Server 4.0

   Introduction:
   -------------
   This document describes the procedure to install NDIS driver on DOS LAN
   Requester for Plug&Play ethernet adapter.

   Location of Driver:  \NDIS2\DOS\PnPCard.DOS  (for DOS LAN Services)


   Installing driver procedure on DOS LAN Requester :
   --------------------------------------------------
      Before  you  start  with  the installation  process,  make sure that
      DOS LAN Services is  properly  installed.  Similarly , your  adapter
      should also be properly installed in your client PC.

      1. Copy  PnPCard.DOS  from  your  Driver diskette  (A:\NDIS2\DOS) to
         DOS LAN Services subdirectory C:\DLS .

      2. Under DOS LAN Requester subdirectory C:\DLS, run INSTALL

      3. The screen display some description.If it's correct,move highlight
         to "The listed options are correct" item ,then press <Enter>.

      4. Move highlight to "Network Card", then press <Enter>.

      5. Select "Change driver for network card." item, then press <Enter>

      6. Select "Network card not shown in list below..",then press <Enter>

      7. Insert the PnPCard driver diskette in floppy A,and specify the path
         A:\NDIS2\DOS, then press <Enter>.

      8. PnPCard driver is now installed on your computer, reboot computer.

      NOTES:
      ------
          Parameters for the PROTOCOL.INI file:

            AdapterID : This keyword is provided by PnPCard,and is required
                        when  more  than  one PnPCard adapters exist on one
                        system.

