   Server Driver for NetWare 4.X

   Introduction:
   -------------
   This  document  describes the procedure to install  the NetWare v4.X
   server driver for the Plug&Play ethernet adapter.

   Location of Driver:     \NetWare\SrvODI\4.x\SRV-PnP.LAN

   Installaton Procedure :
   ---------------------
      Before you start with the installation  process ,  make sure that
      the Novell NetWare v4.X server is properly installed.
      Similarly, your adapter should also be properly installed in your
      server.
      1. Insert the  PnPCard Driver Diskette into drive A  and check the
         contents of subdirectory \NetWare\SrvODI\4.x ,It should contain
         the following file :

         SRV-PnP.LAN  Novell NetWare V4.X Server Driver

      2. At the  NetWare prompt (indicated by the Server name), run the
         INSTALL.NLM program by typing:

         server name: LOAD INSTALL <Enter>

      3. Select "Maintenance/Selective Install" and press <Enter>.

      4. Select  " LAN Driver Options (Configure/Load/...) "  and press
         <Enter>.

      5. Press the <Ins> key to specify other drivers to install.

      6. Press  <F3>  and specify the driver path (A:\NetWare\SrvODI\4.x)
         and press <Enter>.

      7. The Srv-PnP.LAN driver should appear in your choice list for the
         'Select a  LAN  Driver' field. Choose this  driver to start  the
         driver loading and  binding  procedure.  This will allow you  to
         load and bind all 4 frame types supported by NetWare.

      8. Add the  LOAD  and  BIND statements you require to the  server's
         AUTOEXEC.NCF file so that the LAN driver will load automatically
         each time the server starts up.


      Installation Notes:
      -------------------
      1. The  default  frame  type  for  the  NetWare v4.X binding  is
         Ethernet_802.2 and not  Ethernet_802.3.  This is the difference
         between V3.11 and v4.X of NetWare operating system.

      2. Edit the AUTOEXEC.NCF if you want to change some parameters.
         For example,  if you're using a  NetWare  3.11  workstation  and
         wants to log into a NetWare v4.X server. The default frame type
         of NetWare 3.11 is Ethernet 802.3, while that of NetWare v4.X is
         Ethernet  802.2.  Before you can log into the NetWare v4.X, make
         sure  there  is  a protocol  binding for  Ethernet  802.3 in the
         server's AUTOEXEC.NCF file.

