   Workstation for DOS ODI Client

   Introduction:
   -------------
   This document  describes the procedure to setup the NetWare v3.X , v4.X
   workstation driver for the Plug&Play ethernet adapter.

   Location of Driver:     \NETWARE\DOSODI\ODI-PnP.COM

   Sample Configuration Files:
   ---------------------------
      STARTNET.BAT:
         LSL
         ODI-PnP
         IPXODI
         NETX or VLM (VLM's for NetWare 4.X )

      NET.CFG
         LINK DRIVER ODI-PnP
              FRAME ETHERNET_802.2
              FRAME ETHERNET_802.3

   Setup Procedures for NetWare 3.11/3.12 Client :
   -----------------------------------------------
      Before you start with  the installation process , make sure that the
      adapter  is properly installed and configured.  Make sure  that your
      NetWare workstation operating system is properly installed.

      1. Copy ODI-PnP.COM  from the PnPCard  Driver  Diskette  subdirectory
         A:\NWCLIENT to your harddisk.

      2. Create a batch file,or add to your STARTNET.BAT file the commands
         listed above under STARTNET.BAT

      3. Edit the NET.CFG file that you copied over.Edit the file per your
         requirements (see examples above). If there are two  frame  types
         listed,whichever frame type is listed first, that is the one that
         the  driver  will load. See above for examples.  The NET.CFG file
         should be in the same directory with LSL.COM file.


   Setup Procedures for NetWare 4.X Client with vlm:
   -----------------------------------------------
      The  installation  utility   INSTALL.EXE  is  located  on  NetWare's
      "Workstation for DOS" disk. Run INSTALL.EXE from the Workstation for
      DOS Disk.

      The  NetWare  Client  Install program  screen will appear.  You must
      complete each of the questions.  These options are specific  to your
      needs.

      1. Enter the destination directory for the NetWare Client.
         (The default directory is C:\NWCLIENT.)

      2. Gives  you the option to automatically update the CONFIG.SYS  and
         the AUTOEXEC.BAT files or modify them at a later time manually.

      3. Do you wish to install support for MS Windows ? (Y/N)
         (MS Windows Subdirectory: default C:\WINDOWS)

      4. Asks  you to select a network  driver and  provide  configuration
         options.  It uses the  specifications  you select to  create  the
         file NET.CFG.  Insert the PnPCard drivers disk  when prompted for
         the driver disk and specify the driver path A:\NWCLIENT\DOS

      5. Press <Enter> to install


   NOTE:
   -----
         Be  sure  to  add  LASTDRIVE=Z  to  your  CONFIG.SYS file for the
         network mappings to work properly.
