   Installation guide for Windows NT 4.0 about PnPNIC driver.

   Introduction:
   -------------
   This document describes the procedure to install Windows NT4.0 driver
   for the Plug&Play ethernet adapter.

   Location of Driver:     \WINNT40\PnPCard.SYS

   Installing driver procedure on Microsoft Windows NT :
   -----------------------------------------------------
   When you are in Windows NT4.0;
   1. In the "My computer" group of NT4.0,select the "Control Panel"icon.

   2. In the Control Panel window, choose the "Network" icon.

   3. In the Network Settings dialog box, choose the "Adapters" button,

      then choose "Add.." button.

   4. When Network Adapter dialog box appears. Select "Have Disks"button.

   5. Insert  the driver disk in drive A: , enter  full path  A:\WINNT40

      where the driver PnPCard.SYS and setup file OEMSETUP.INF are located

      , then choose the [OK] button.

   6. Select the card title "PNPCARD PnP Ethernet Adapter".

   7. NT40 will then perform the binding process.If any additional network
      software options were installed,  you may be  prompted for  specific
      information for these packages.

   8. Restarting your system you will acquire network service.
